[Scooter]

It was a bitch to get wired in because of the aftermarket deck that was in and the wires were all hacked up. Then, of course, the wiring diagram for a North American E36 didn't match my car, but there was a wiring diagram on the top of the deck that was in the car, so I went off that in conjunction with the NA wiring diagram that matched the replacement harness I had. I got it all spliced in and it seems to be working just fine

Next I have to figure out how to reattach the hookup for the radio because that was hacked up too. Must be witch craft that I'm still able to get radio signal without having it hooked up





Installed, but not totally flush. I didn't mess with it too much to get it to fit since I'm going to have to pull it again to get the antenna hooked up properly.



And here's the wiring diagram I had to go off to get things wired up. A bit of translation was required to figure out which was front and rear